Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10.4 ASSEMBLE THE TUBE
ASSEMBLY
The tube assembly can be disconnected from the
backpack assembly.
1. Press the blower release button (14) and pull up
to disconnect the tube assembly from the backpack
assembly.
10.5 INSTALL THE BATTERY PACK
17
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read and understand the instructions in the
battery and charger manual.
1. Unlock the latches (15) on both sides to release the
dust cover.
2. Remove the dust cover (16) to expose the battery
compartment.
3. Align the battery pack with the cavity in the
backpack housing.
4. Insert the battery pack into the backpack housing.
14
15
WARNING
English
5. Push the battery pack into the backpack until it locks
into place. You will hear a click once it is locked into
place.
6. Do not use force when inserting the battery pack. It
should slide into place and click.
Please keep the dust cover installed to prevent entry
of dust or water.
The blower can hold two batteries, but only one of the
batteries works during operation.
10.6 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (17).
2. Remove the battery pack from the machine.
10.7 ADJUST THE HARNESS
1. Fit the backpack on your back.
2. Pull the ends of the straps down to tighten the
harness.
3. Connect the horizontal chest strap.
4. Pull the end of the chest strap to tighten.
16
8
NOTE
NOTE
1
2
Publicidad
Solución de problemas
