Operating Procedure - avdel 07536 Manual De Instrucciones

P u t t i n g i n t o S e r v i c e
Loading and Re-loading the Tool
Setting the Tool - Adjustable Nose Assemblies Only
Insert the previously assembled mandrel (see Loading the Tool
Assembly 60.
While holding the mandrel, close the Tail Jaws 32, which grip the mandrel, by switching on the tail jaw switch (18 and 19).
Screw the lock nut onto the Barrel 44 of the tool.
Rotate the nose assembly onto the Barrel 44.
Adjust the nose assembly so that the first fastener protrudes by 1,5mm-3mm (1/16"-1/8"), as shown in the illustration on page 9.
Tighten the lock nut against the nose assembly to prevent the nose jaw assembly from moving.
Re-loading the Tool
Open the tail jaws of the tool, by switching off the tail jaw switch (18-19).
Open the jaws and pull the empty mandrel and follower spring out of the tool.
Insert the new mandrel against the stop within the too, and close the Tail Jaws 32 which grip the mandrel, by switching on the tail jaw
switch (18 and 19).
Close the Tail Jaws 32.
O p e r a t i n g P ro c e d u r e
You must check that the cursor orientation and the nose equipment are correct before attempting to operate the tool.
•
Push the fastener, protruding from the nose jaws, fully into the application holes ensuring that the tool is held square.
•
Operate the trigger without releasing - the mandrel head is pulled through the fastener, forming the fastener into the application.
•
Remove the tool.
•
Release the trigger. The next fastener will be automatically presented through the nose jaws, ready for placing.
Item numbers in bold refer to the general assembly and parts list for the 07536-02200 on pages 16-17.
10
•*
) or the disposable mandrel against the stop within the Tail Jaw Piston
IMPORTANT