Scott SOLACE GRAVEL eRIDE 30 Manual página 4

1.2 Intended Use
The Display V01 and the Remote V01 of the drive system are intended exclu-
sively for Displaying information and operating your e-bike and must not be
used for other purposes.
Any other use or use that goes beyond this is considered improper and will
result in the loss of the warranty. In case of non-intended use, TQ-Systems
GmbH assumes no liability for any damage that may occur and no warranty
for proper and functional operation of the product.
Intended use also includes observing these instructions and all information
contained therein as well as the information on intended use in the supple-
mentary
documents enclosed with the e-bike.
Faultless and safe operation of the product requires proper transport, storage,
installation and operation.
1.3 Safety instructions for working on the e-bike
Make sure that the HPR50 drive system is no longer supplied with power
before doing any work (e.g. cleaing, chain maintenance, etc.) on the e-bike:
► Switch off the drive system at the Display and wait until the Display has
disappeared.
Otherwise, there is a risk that the drive unit may start in an uncontrolled way
and cause serious injuries, e.g. crushing, pinching or shearing of the hands.
All work such as repair, assembly, service and maintenance be carried out
exclusively by a bicycle dealer authorized by TQ.
1.4 Safety instructions for the Display und Remote
— Do not be distracted by the information shown on the Display while riding,
concentrate exclusively on the traffic. Otherwise there is a risk of an acci-
dent.
— Stop your e-bike when you want to perform actions other than changing
the assistance level.
— The walk assist that can be activated via the Remote must only be used to
push the e-bike. Make sure that both wheels of the e-bike are in contact
with the ground. Otherwise there is a risk of injury.
— When the walk assist is activated, make sure that your legs are at a safe
distance from the pedals. Otherwise there is a risk of injury from the
rotating pedals.
EN - 3