Publicidad
Digital-to-Analogue Converter 192 kHz
EN
Convertisseur Numérique-Analogique 192 kHz
FR
• In case of emergency, after use and during a thunders-
torm, pull the mains plug out of the socket directly at the
plug housing.
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
A defective device may not be put into operation, but must be
disconnected from mains and protected against further use.
• Use product, product parts and accessories only in per-
fect condition.
• Avoid stresses such as heat and cold, moisture and di-
rect sunlight, microwaves, vibrations and mechanical
pressure.
• In case of questions, defects, mechanical damage, troub-
le and other problems, non-recoverable by the documen-
tation, contact your dealer or producer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against ac-
cidental use.
Heat storage
• Do not cover the product.
• Keep enough space around all devices for a good ventla-
tion and free motion and to avoid damages.
2 Description and function
2.1 Product
The product is a digital-to-analogue converter including pow-
er supply that converts digital input signals into analogue out-
put signals.
2.2 Scope of delivery
Digital-to-Analogue Converter 192 kHz, Power supply, Char-
ging cable, User Manual
2.3 Operating Elements
See Fig. 1.
1 Toslink socket
2 Coaxial socket
3 DC socket
4 3.5 mm jack socket
5 LED status indicator
6 RCA socket (R)
3 Intended use
This product is intended exclusively for private use
and its intended purpose. This product is not inten-
ded for commercial use. We do not permit using the
device in other ways like described in chapter „Description
and Function" or in the „Safety Instructions". Use the product
only in dry interior rooms. Not attending to these regulations
and safety instructions might cause fatal accidents, injuries,
and damages to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and in-
tegrity.
2. Compare the specifications of all used devices and ensu-
re compatibility.
5 Connection and operation
NOTICE!
• Switch off all units to be connected and the converter be-
fore connecting or disconnecting the units via the connec-
tion sockets.
See Fig. 2.
1. Connect a source device to the Toslink socket (1) or co-
axial socket (2) of the converter.
If two source devices are connected, the Toslink socket is
active. Make sure that the input signal is digital, otherwise
errors may occur.
2. Connect your output device to the 3.5 mm jack socket (4)
or the RCA socket (6+7) of the converter.
Connection cables are not included in the delivery. Make
sure that the source and output devices as well as the con-
nection cables support the standards of the product!
3. Connect the USB-A plug (11) of the charging cable to the
USB-A socket (9) of the power supply.
4. Plug the Euro plug (8) of the power supply into a free and
easily accessible socket.
REV2022-11-14
Subject to change without notice. |
V1.0aw
Sous réserve de modifications.
7 RCA socket (L)
8 Euro plug
9 USB-A socket
10 DC plug
11 USB-A plug
Material damage
5. Connect the DC plug (10) of the charging cable to the DC
socket (9) of the converter.
The converter is now supplied with power and the LED sta-
tus indicator (3) lights up red.
6. Switch on the source and output devices.
7. After use, switch the source and output devices off again
and disconnect all cable connections.
6 Maintenance, Care, Storage and
Transportation
The product is maintenance-free.
NOTICE!
• Always disconnect the mains plug before cleaning.
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry
and dust-protected ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.
7 Disposal instructions
According to the European WEEE directive, electrical
and electronic equipment must not be disposed with
consumers waste. Its components must be recycled
or disposed apart from each other. Otherwise conta-
minative and hazardous substances can damage the
health and pollute the environment.
As a consumer, you are committed by law to dispose electri-
cal and electronic devices to the producer, the dealer, or pub-
lic collecting points at the end of the devices lifetime for free.
Particulars are regulated in national right. The symbol on the
product, in the user manual, or at the packaging alludes to
these terms. With this kind of waste separation, application,
and waste disposal of used devices you achieve an important
share to environmental protection.
WEEE No: 82898622
1 Consignes de sécurité
Le mode d'emploi fait partie intégrante du produit et com-
prend d'importantes informations pour une bonne installation
et une bonne utilisation.
• Lisez le mode d'emploi attentivement et complètement
avant de l'utiliser.
Le mode d'emploi doit être disponible à des incertitudes et
transfert du produit.
• Conservez soigneusement ce mode d'emploi.
Notes pour la séparation des réseaux
Le produit n'a pas d'interrupteur d'alimentation et peut être
utilisé que dans des points facilement accessibles en cas
d'urgence et rapidement après l'utilisation de cette pour les
supprimer.
Sans surcharge de tension uniquement lorsque le bouchon
est tiré.
• En cas d'urgence, après l'utilisation et pendant un orage,
retirez la fiche secteur de la prise directement au niveau
du boîtier de la fiche.
• Ne pas ouvrir le boîtier.
• Ne modifiez pas le produit et les accessoires.
• Pas court-circuiter des connexions et circuits.
Un appareil défectueux ne doit pas être mis en service. Il doit
au contraire être immédiatement mis hors tension et protégé
contre toute utilisation involontaire.
• Utilisez le produit, pièces et accessoires des produits uni-
quement en parfait état.
• Éviter des conditions extrêmes, telles que la chaleur ex-
trême et froid, l'humidité et de la lumière directe du so-
leil, ainsi que microondes, des vibrations et de la pressi-
on mécanique.
• En cas de questions, les défauts, les dommages mécani-
ques, des ingérences et d'autres problèmes, non récupé-
rables par la documentation, contactez votre revendeur
ou le producteur.
Non destiné à des enfants. Le produit n'est pas un jouet !
• Sécuriser l'emballage, petites pièces et l'isolation contre
l'utilisation accidentelle.
- 3 -
Pillmannstraße 12 | 38112 Braunschweig | Germany
58493
Material damage
Goobay® by Wentronic GmbH
Publicidad
