Worx Nitro WX352 Manual De Instrucciones página 13

ASSEMBLY
CHUCK ADJUSTMENT
Warning: Always lock off trigger switch and
disconnect tool from power source when
changing accessories. Always ensure the bit is
secure before starting the tool. Damage to the Chuck or
a loose bit may cause possible personal injury.
--Removing the bits
--Inserting the bits
-- Assembling the belt hook and
bit clip
OPERATION
Forward/reverse rotation control
Warning: Never change
the direction of rotation
when the chuck is
rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING,
HAMMER DRILLING
Operating the on/off switch
Warning: Do not operate
for long periods at low
speed because excess
heat will be produced
internally.
20V Cordless Impact Drill
LED light indicator (See Fig. G)
Before operation, the LED light will be activated when
the On/Off switch is slightly depressed, and will
automatically turn off 20 seconds after the On/Off switch
is released.
The tool and battery are equipped with a protection
See Fig.B1
system. When the LED Light is quickly flashing 60
seconds and turn off, the system will automatically cut
See Fig.B2
off power to the tool to extend battery life. The tool will
automatically stop during operation if the tool and/or
See Fig. C1, C2,
battery are placed under one of the following conditions:
C3, C4
• Overloaded: The tool is operated in a manner that
causes it to draw an abnormally high current. In this
situation, release the Trigger Switch on the tool and
stop the application that caused the tool to become
overloaded. Then pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool
See Fig.D1, D2, D3
does not start, the Tool and Battery are overheated. In
this situation, let the Tool and Battery cool before pulling
the Trigger Switch again.
• Low battery voltage: The remaining Battery capacity
is too low and the tool will not operate. In this situation,
See Fig. E
remove and recharge the Battery.
See Fig. F1, F2, F3
6.PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The Forward and Reverse Switch, which is on top of
See Fig. G
the trigger, is positioned in the lock function. Unlock
the Forward and Reverse Switch putting it into the
required rotation position. Push the trigger and the
drill will start to rotate (See Fig. B).
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the Torque Adjustment
Ring, you can find the Torque Adjustment Ring
between the Chuck and the drill body. Position
1 is the lowest torque (screw driving force) and
position 22 is the highest torque (screw driving
force). Position is for drill operation. Position
is for hammer drill operation. Regulate the Torque
Adjustment Ring to a higher position to reach the
best result (See Fig. E).
3. I CAN NOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
The battery can be inserted into the charger only in
one direction. Turn the battery around until it can be
inserted into the slot, the red LED Light should turn
on when the battery is charging.
4. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
WARNING: To turn on the light, press the On/Off
switch and make sure the Forward/Reverse
Rotation Control is on right/left position.
13
EN