ST T 92 Serie Guía Rápida De Uso página 117

3.2. STEERING WHEEL ASSEMBLY
See figure 3.
3.3. SEAT ASSEMBLY
See figure 4.
Pull on the adjustment lever upward and insert the seat in
the guide on the side of the steering wheel until it engages.
3.4. MOUNTING AND CONNECTING THE
BATTERY
See figure 5.
First connect the red wire (Fig. 5.C) to the positive pole (+)
and then the black wire (Fig. 5.D) to the negative pole (–),
using the screws supplied as shown.
Mount the battery retaining spring (Fig. 5.B), making sure that
the cables are routed correctly in front of the battery, so that
they are not pinched by the spring (Fig. 5.B).
3.5. FITTING THE SUPPORTS AND REMOVING
THE GRASS CATCHER RETAINING PAWL
See figure 6 and 7.
3.6. MOUNTING THE REAR BUMPER
Type "I" bumper: see figure 8-I.
Type "II" bumper: see figure 8-II.
3.7. GRASS CATCHER BAG ASSEMBLY
See figure 9.
3.8. MOUNTING THE GRASS CATCHER
TIPPING LEVERS
See figure 10.
3.9. MOUNTING THE CUTTING MEANS
ASSEMBLY LATERAL SAFETY PANELS (IF
FITTED)
See figure 11.
3.10. SIDE DISCHARGE CHUTE ASSEMBLY
(FOR MODELS WITH SIDE DISCHARGE
ONLY)
See figure 12.
4. CONTROLS
• Brake pedal (Fig. 13.A and 14.A)
This pedal operates the brakes
on the rear wheels.
• Forward drive pedal (Fig. 13.B and 14.B)
Forward drive gear: Increasing the
pressure on the pedal progressively
increases the speed of the machine.
Neutral position: The pedal automatically
goes into neutral position when released.
• Reverse drive pedal (Fig. 13.C and 14.C)
Reverse gear: Increasing the pressure
on the pedal progressively increases
the speed of the machine.
when the machine has stopped.
Neutral position: The pedal automatically
goes into neutral position when released.
• Hydrostatic drive unlocking control (Fig. 13.D and 14.D)
Drive engaged.
Drive disengaged.
• Key switch(Fig. 15.A)
The key enables/disables the machine ignition.
Stop position.
On position.
Start position.
IMPORTANT Remove the key whenever the machine is left
unattended or not in use.
• Throttle command
Type "I" with separate Choke command (Fig. 15.B and
Fig. 15.C)
Type "II" (Fig. 15.C)
Choke Command - Cold start (if equipped).
Maximum engine speed.
Minimum engine speed.
• Parking brake lever
Brake not engaged.
EN - 4
Reverse must only be engaged
(Fig. 15.D)