ST T 92 Serie Guía Rápida De Uso página 124

8. TROUBLESHOOTING
PROBLEM
1. When the key is turned
to the "ON" position,
the dashboard fails to
switch on and there
is no acoustic signal
2. When the key is turned
to the "ON" position,
the dashboard
fails to switch on
but the acoustic
signal is activated
3. With the key on
"START" the
dashboard is
illuminated, but
the starter motor
does not run
4. With the key on
"START" the starter
motor runs but the
engine does not start
5. Starting is difficult
or the engine
runs erratically
6. Weak engine
performance
during cutting
7. The engine stops
when the cutting
device are engaged
8. The battery indicator
light remains on even
after the machine
has been running
for a few minutes
9. The oil indicator light
switches on during
operation (if fitted)
10. The engine stops
running and an
acoustic signal
is generated
11. The engine stops
running, and no
acoustic signal
is generated
PROBABLE CAUSE
The safety device of the electronic
circuit board has cut in due to:
badly connected battery
battery terminals inverted
battery completely discharged
fuse blown
wet circuit board
The safety device of the electronic
circuit board has cut in due to:
wet circuit board
insufficiently charged battery
battery charger fuse blown
insufficiently charged battery
faulty fuel supply
faulty ignition
carburation problems
forward speed too high in
relation to the cutting height
engage not enabled
insufficient battery charge
engine lubrication problems
The safety device of the electronic
circuit board has cut in due to:
over-voltage caused by
the charger regulator
battery not connected
correctly (poor contacts)
battery disconnected
engine problems
Turn the ignition key to "STOP" position
and look for the cause of the problem:
check the connections (par. 3.4)
check the connections (par. 3.4).
recharge the battery (par. 6.4)
replace fuse (10 A)
dry using lukewarm air
Turn the ignition key to "STOP" position
and identify the cause of the problem:
dry using lukewarm air
recharge the battery (par. 6.4)
replace fuse (25 A)
recharge the battery (par. 6.4)
check the level in the tank (par. 6.2)
open the fuel stopcock (if foreseen) (par. 5.4)
check the fuel filter
check that the spark plug cap is securely fitted
check that the electrodes are clean
and have the correct gap
clean or replace the air filter
empty the fuel tank and refill with fresh fuel
check and replace the fuel filter if necessary
reduce the forward speed and/or
raise the cutting height (par. 5.4)
check that all starting conditions
are met (par. 5.2)
contact your Dealer
Turn the key to the "STOP" position immediately:
top-up the oil level (see 6.2)
replace the filter (if the problem
persists, contact your Dealer)
Turn the ignition key to "STOP" position
and identify the cause of the problem:
contact your Dealer
check the connections (see 3.4)
check the connections (see 3.4)
contact your Dealer
EN - 11
SOLUTION