Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
- Professional digital stereo power amplifier with high efficiency class D amplifier circuit and switch-mode
power supply.
CONTROLS AND FUNCTIONS
FRONT PANEL
POWER: device on/off switch.
1.-
2.-
Volume control for each channel.
CLIP: LEDs indicating the peak signal of each channel. If they light up dimly or occasionally you should
3.-
decrease the output volume. If the LEDs remain on continuously, it is because the input signal is very high.
In this case, reduce the volume of the input signal by adjusting the control that generates this signal.
SIGNAL: LEDs indicating the output signal of each channel.
4.-
ON: LED indicating that the power stage is working.
5.-
REAR PANEL
STEREO/PARALLEL/BRIDGE: selector of the operating mode of the outputs of the power amplifier.
1.-
You can select between Bridge, Stereo or Parallel mode.
GND/LIFT: this selector is normally set to the GND position. If the system makes grounding noises,
2.-
switch the selector to the LIFT position to disconnect the ground from the device.
INPUTS CH A,CH B: balanced line level signal inputs for channels A and B, combo connectors (XLR
3.-
and 6.3 mm jack).
In bridge and parallel mode, the input should be INPUT CH A.
OUTPUTS CH A, CH B: speaker output terminals for channels A and B.
4.-
For stereo and parallel modes, connect 4-8 Ω speakers to the output connectors taking into account
the power indicated on the outputs. Speaker connectors, screw terminals or bananas plugs (see
power and connections on the print inscribed on each connector).
For bridge mode connect 8 Ω speakers using the positive (+) connectors on the screw or banana
terminals, or the CH A loudspeaker connector (see power and connections on the print inscribed on
each connector).
5.-
Input for AC power cable.
AC SELECT: power supply voltage selector.
6.-
2
Publicidad
