Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LDSSQ4/LDSSQ6 Commercial Recessed LED Rough-In
Ceiling Cutout
LDSSQ4
5-1/2" x 5-1/2"
LDSSQ6
7" x 7"
INSTALLATION
Rough-In Section
1.
Install fixture into ceiling cavity using 1/2˝ electrical
conduit. Use 3/4˝ channel, 1-1/2˝ channel, 1/8˝ x 1/2˝
bar stock, or T-bar fasteners as mounting rails (furnished
by others) by inserting the through hanger brackets at
both sides.
2.
Adjust torsion spring receiver screws (Figure 1.) so
bottom of neck is flush with finished ceiling line.
(Figure 2.) Hanger bracket is reversible for total
adjustment of 5˝.
3.
Remove one of the junction box covers. Connect supply
lead wires to lead wires of driver as per Wiring Diagram
and in accordance with your local electrical code(s) or
N.E.C. (Figure 11)
Torsion Spring Receiver Height
Adjustment Thumb Screw
Figure 1
2
Installation Instructions – LDSSQ4/LDSSQ6 Commercial Recessed LED Rough-In www.cooperlighting.com
Adjust to Bottom of Ceiling
Figure 2
Trim Installation
1.
Place end of flexible conduit through frame opening
in ceiling exposing upper portion of quick disconnect
(Figure 2.).
2.
Remove LED engine from protective packaging.
3.
Remove trim assembly from protective packaging and
rotate side clips (3) outwards. (Figure 3).
4.
Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly (Figure 4)
5.
Rotate side clips (3) into place to securely attach trim
assembly to LED engine (Figure 5).
6.
Trim ring (optional) should be placed between the
ceiling and lower trim.
Luminaire
Quick
Disconnect
Figure 3
Junction Box
Figure 4
Publicidad
