Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the appliance
6mm
3mm
Remove the pan supports, the burner lid and flame spreader and carefully turn the appliance upside
1.
down and place it on a cushioned mat.
2.
Take care that the Ignition devices and flame supervision devices are not damaged in this operation.
Apply the sponge provided around the edge of the appliance.
3.
Do not leave a gap in the sealing agent or overlap the thickness.
(C) SCREW
Gas Connection
This appliance must be installed and connected in accordance with installa- tion
regulations in force in the country in which the appliance is to be used.
This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG
and natural gases must only be undertaken by a qualified person.
3mm
(A) SEALING STRIP
(B) BRACKET
Gas supply replacement and installation guidelines:
LPG > NG
seal
The gas rail
G1/2"Female coupler
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
Place the bracket (B) over the holes that match the
size of the screws.There are one set of screw holes in
each corner of the hob (H).Slightly tighten a screw (C)
through the bracket (B) so that the bracket is attached
to the hob, but so that you can still adjust the position.
2.
Carefully turn the hob back over and then gently lower
it into the aperture hole that you have cut out.
On the underneath of the hob, adjust the brackets into
3.
a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into
position.
NG > LPG
The gas rail
16
seal
Ø11.5 Female coupler
Publicidad
