Connect Door Arm To Trolley; Sectional Doors Only - Craftsman 139.536481DM Manual Del Propietário

INSTALLATION STEP 12

Connect Door Arm to Trolley

Follow instructions which apply to your door type as illustrated
below and on the following page.

SECTIONAL DOORS ONLY

• Make sure garage door is fully closed. Pull the emergency
release handle to disconnect the outer trolley from the inner
trolley. Slide the outer trolley back (away from the door) about
2" (5 cm) as shown in Figures 1, 2 and 3.
• Figure 1:
– Fasten straight door arm section to outer trolley with the
5/16"x1" clevis pin. Secure the connection with a ring
fastener.
– Fasten curved section to the door bracket in the same way,
using the 5/16"x1-1/4" clevis pin.
• Figure 2:
– Bring arm sections together. Find two pairs of holes that line
up and join sections. Select holes as far apart as possible to
increase door arm rigidity.
• Figure 3, Hole alignment alternative:
– If holes in curved arm are above holes in straight arm,
disconnect straight arm. Cut about 6" (15 cm) from the solid
end. Reconnect to trolley with cut end down as shown.
– Bring arm sections together.
– Find two pairs of holes that line up and join with bolts, lock
washers and nuts.
• Proceed to Adjustment Step 1, page 27. Trolley will re-engage
automatically when opener is operated.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 Lock Washer 5/16"
Clevis Pin
5/16"x1" (Trolley)
Ring Fastener
Clevis Pin Hex Bolt
5/16"-18x7/8"
5/16"x1-1/4" (Door Bracket)
Outer Trolley
Figure 1
Figure 2
Nuts
5/16"-18
Door Bracket
Figure 3
Nuts
5/16"-18
Figure 4
CORRECT
Straight
Door Arm
Curved
Groove
Door Arm
Facing Out
25
Inner Trolley
Ring
Fastener
Door
Bracket
Straight
Door Arm
Curved
Door Arm
Clevis Pin
5/16"x1-1/4"
Lock
Washers
5/16"
Bolts
5/16"-18x7/8"
Lock
Washers
5/16"
Bolts
5/16"-18x7/8"
Cut This End
INCORRECT
Straight
Door Arm
Curved
Door
Arm
Clevis Pin
5/16"x1"
Emergency
Release
Handle