ST E 300 Li 40 Serie Manual De Instrucciones página 21

3. ABOUT THE MACHINE
3.1 MACHINE DESCRIPTION AND INTENDED USE
This machine is pedestrian-controlled lawnmower.
The machine is essentially composed of a motor
which drives a cutting means enclosed in a
casing, equipped with wheels and a handle.
The operator is able to operate the machine and use
the main controls, always staying behind the handle
at a safe distance from the rotating cutting means.
If the operator leaves the machine, the motor and
cutting means will stop within a few seconds.
3.1.1 Intended use
This machine is designed and built to cut (and
collect) grass in gardens and grassy areas,
with a height according to its cutting capacity,
driven by an operator walking behind it.
Generally speaking this machine can:
1. mow the grass and collect it in the grass catcher;
2. mow the grass and discharge it on the
ground through the rear part;
3. mow the grass, chop it and discharge it on
the ground (mulching effect - if available).
The use of special attachments provided for by the
Manufacturer as original equipment or which may be
purchased separately, allows this work to be done in
various operating modes, illustrated in this manual or the
instructions that accompany the single attachments.
3.1.2 Improper use
Any other use that does not comply with the
above, can be dangerous and cause damage to
people and/or property. Examples of improper
use may include, but are not limited to:
– Allowing children, animals or other passengers on the
machine as they could fall off and injure themselves
or compromise safe driving by the operator;
– Letting oneself be transported by the machine;
– Using the machine to tow or push loads;
– Using the cutting means on surfaces other than grass;
– Using the machine for leaf or debris collection;
– Using the machine to trim hedges, or for
cutting vegetation other than grass;
– Using of the machine by more than one person;
IMPORTANT Improper use of the machine will
void the warranty and relieves the Manufacturer of
any liability, placing all responsibility for damage or
injury, to him/herself or third parties, on the user.
3.1.3 Type of users
This machine is intended for use by consumers,
i.e. non-professional operators. It is intended
for "hobby-related activities".
IMPORTANT The machine must
be used by one operator.
3.2 SAFETY SIGNS
The machine has various symbols on it (fig. 2). Their
function is to remind the operator of the correct
conduct for use, with due care and caution.
Meanings of the symbols:
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an Authorised Service Centre.
3.3 IDENTIFICATION LABEL
The identification label holds the following data (Fig.1).
1. Sound power level
2. CE conformity marking
3. Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
8. Max. motor operation speed
9. Weight in kg
10. Power voltage and frequency
11. Electrical protection rating
12. Maximum and nominal power
Write the identification data of the machine in the specific
space on the label on the back of the cover page.
EN - 4
Warning: Read the instructions
before use.
Danger! Risk of projected ob-
jects: Keep all persons outside the
work area during machine use.
Danger of cutting. Cutting means
in motion. Do not put your hands or
feet inside the housing of the cutting
means.
Be careful when using the cutting
means: Do not insert hands or feet
into the cutting means housing. The
cutting means continues to turn even
after the motor has been switched
off. Remove the safety key (deactiva-
tion device) before any maintenance
is carried out.