Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installing the Bidet Attachment
1. Install adjustable mounting brackets into
the bidet attachment
Place circular mounting brackets into
the circular openings of the bidet
attachment.
Step 1
2. Install bidet attachment on toilet
a. Place the bidet attachment on the
toilet with the nozzle close to the
back of the toilet, leaving a slight gap
between the toilet and the nozzles.
This will vary by toilet.
b. Make sure the adjustable brackets line
up with the holes in the toilet fixture.
You may need to rotate the adjustable
brackets accordingly to line up properly.
Step 2b
c. Add large white mounting washers if
needed for a better fit.
d. Replace the toilet seat on top of the
bidet attachment and secure using
original toilet seat hardware. Make
sure to tighten so that the bidet
attachment and seat do not move.
Step 2d
10
e. Ensure the bidet control knob is in
the off position to prevent water
from accidently spraying out of the
toilet bowl.
3. Connect bidet hose to bidet attachment
Connect the open end of bidet hose
to the cold connection under the bidet
attachment.
Step 3
NOTE: If you have already installed the
hot water supply cap over the hot water
supply on your SSE-25 Dual Temperature
model, skip to Step 5 on Page 11.
Otherwise, proceed to the next steps.
4. Connect hot water tube to bidet
attachment (SSE-25 dual temperature
model only)
a. Take the hot water tubing pressure
connector and remove the pressure
cap.
b. Slide the pressure cap over the open
end of the of hot water flex tubing
with the inside threads facing towards
the open end.
Step 4b
Publicidad
