Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installing the Bidet Attachment (Cont'd)
c. Push the pressure connector into
the open end of the of hot water flex
tubing with the washer facing out.
Step 4c
IMPORTANT: Be sure to slide the hot
water flex tubing over the pressure
connector until the tubing slides past
the "lip" of the pressure connector and
it cannot go any further.
d. Hold the pressure connector up
against the hot water inlet on the
bidet attachment. Slide the pressure
cap along the tubing and screw the
cap onto the hot water inlet until the
pressure connector is secure.
Step 4d
5. Turn on water supply and check for leaks
a. Open the main water supply valve
slowly and check for leaks.
b. Wait 5-10 minutes, check again, and if
there are no leaks, continue.
NOTE: If there is any leaking, check all
rubber washers and make sure all water
connections are tight and secure. If
necessary, wrap Teflon tape around the
threading of any leaking connections.
11
Publicidad
