Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Before Installation
IMPORTANT:
Please be advised that the provided cold
water T-Valve should be installed at the
fill valve under the toilet tank. Do not
disconnect from water supply valve on
the wall.
NOTE: The hot water T-Valve will be
installed at the hot water supply under
your bathroom sink. If you do not have
access to the fill valve under the toilet
tank, visit us at www.brondell.com
or contact us at 1-888-542-3355 for
further assistance.
For SSE-25 Dual Temperature Model Only
Check the size of the hot water supply
connection (most likely under the
sink/washbasin). This should be a 3/8"
connection to properly fit and install the
enclosed T-Valve.
NOTE: If the connection is a ½"
connection, you will need to
purchase the following reducing
adapter available online and at many
plumbing hardware stores: Reducing
Adapter, ½" Female NPT x ⅜" Male
Compression
6
Check water supply line
Check the water supply line that connects
the toilet tank fill valve to the water shut-off
valve at the wall.
• If it is a rigid pipe, you will need to
purchase a flexible water supply hose
to replace it before installing the
SimpleSpa Eco.
• The length of the hose may vary, and
the top connection size should be 7/8"
ballcock to connect to the T-Valve that
you will install under the toilet tank.
• The bottom connection will vary
(most common are 3/8" and ½" female
compression).
CAUTION: Only use the hoses,
T-Valves, and components that are
included with your product as they
have been specifically designed and
tested for safe use with this Bidet
Attachment. Please note that use
of unauthorized or non-Brondell
approved parts could result in injury,
leaking, or damages that Brondell will
not be held liable for.
Publicidad
