Publicidad
Idiomas disponibles
Idiomas disponibles
Initial Commissioning
Information on Initial Commissioning
Note: These Instructions describe how to perform initial commissioning
without provisioning.
1.
Mount the device feet (figure A 1 under Assembly).
Connect the device (figure A 2 under Assembly).
2.
The company logo is displayed for 2 to 3 minutes. The Message
key flashes. The system displays a message that it is searching for
provisioning files. The telephone's IP address is shown on the display at
the same time.
3.
Note the IP address.
4.
Return to the menu First setup.
• Softkey Cancel
Note: Make the settings afterwards as follows:
• Navigate in lists using the direction keys
• Use the keypad to enter numbers and characters.
• Confirm your selection or entry with
Configuring the language and location
1.
Set the menu language.
• Softkey Country > Phone language
2.
Configure the location.
• In the phone: Location
3.
Set the language of the web interface.
• In the phone: Web interface
The menu First setup you can reach via Back
You can do one of the following:
• Configuring identity on the phone (chapterConfiguring identity on
the phone)
• Get access to the web interface to make settings via the web interface
(see chapter Open web interface).
− Softkey WebUI > Access > Web administration (https)
Configuring identity on the phone
1.
Menu > Settings > Identities
2.
Select an Identity that has not been set up and enter the following data:
Note: Hold down the digit keys to enter numbers.
SIP Username
PBX
the internal number configured
for the phone
.
.
.
VoIP provider
The username configured for
the account
Publicidad
