8.
Assembling
•
The condenser is pre-installed in the factory. To remove the
condenser use an Allen wrench 1,5 mm diam and operate on
the locking screw placed on the right side of the condenser
holder.
1. Insert the spacer ① above the stand and tighten the screw
②. (Fig. 1)
2. Using the supplied screws, join the fixing plate mounted on
the camera ③ and the fixing plate mounted on the monitor
④. (Fig. 2)
3. Screw the "C" mount adapter ⑤ to the camera
insert the round dovetail of the "C" mount into the empty hole
of the spacer, then tighten the clamping screw ⑦. (Fig. 4)
③
⑥
(Fig. 3) and
Page 9
④
⑤
①
②
F ig. 1
F
ig. 1
F ig. 2
F
ig. 2
⑥
F ig. 3
F
ig. 3
⑦
F
F ig. 4
ig. 4