Publicidad
Idiomas disponibles
Idiomas disponibles
D-Fi USB Connectivity
The 4BAR Flex Q ILS is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi USB from CHAUVET
DJ. Simply set the DIP switch D-Fi receiving/transmitting channel, plug it into the USB port then set the product's DMX
Personality and DMX Address.
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may cause
damage to the product.
Once plugged in, the D-Fi USB will take over the product. Wired DMX and manual display control/menu
buttons will be unavailable until you unplug the D-Fi USB. The priority levels are:
1. D-Fi USB
2. Wired DMX
3. IRC-6 Remote Control
4. Manual Digital Display/Menu Buttons
Master/Slave Mode (D-Fi USB)
The D-Fi USB allows a single 4BAR Flex Q ILS product (the "master") to control the actions of one or more
4BAR Flex Q ILS products (the "slaves") without the need of a DMX controller or DMX cables. The master (transmitter)
product will be set to operate in standalone mode, while the slave (receiver) products will be set to operate in DMX mode.
Once set and connected, the slave products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 9-Ch shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to set the starting address to d 1.
4. Press <ENTER>.
5. Set the D-Fi USB to receive on a specific channel, 1–16.
6. Plug in the D-Fi USB.
7. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode.
2. Set the D-Fi USB to transmit on the D-Fi channel the slaves are receiving on.
3. Plug in the D-Fi USB.
•
All products must be set to the same DMX personality, DMX address, and D-Fi channel.
•
Configure all the slave products before configuring the master to transmit.
•
Never connect a DMX controller to a D-Fi channel configured for Master/Slave operation because the
controller may interfere with the signals from the master.
ILS Mode
ILS (Integrated Lighting System) provides 4 modes that synchronize with the GigBAR MOVE+ILS: Modes 1 and 3
synchronize with side 1 of the GigBAR MOVE+ILS, whereas modes 2 and 4 synchronize with side 2 of the GigBAR
MOVE+ILS. When linked, effects will sync with the most similar effect on the selected side of the GigBAR MOVE+ILS:
Kinta effects will sync with one of the kintas, moving heads will sync with one of the moving heads, and wash effects will
sync with one of the pars. Laser effects will sync with the laser, and strobe effects will sync with the strobe effects
regardless of ILS mode.
This product will synchronize with the par effects of the GigBAR MOVE+ILS, regardless of ILS mode.
To set the 4BAR Flex Q ILS to respond to an ILS signal:
1. Press <MENU> repeatedly until iLS_ shows on the display.
2. Use <UP> or <DOWN> to select from iLS1 (side 1), iLS2 (side 2), iLS3 (side 1), or iLS4 (side 2).
3. Press <ENTER>.
4BAR Flex Q ILS QRG Rev. 2
QUICK REFERENCE GUIDE
EN
4
Publicidad
