Technical Characteristics - PRESIDENT New JIMMY Manual Del Usuario

5) ANL:
Automatic Noise Limiter. This filter allow the reduction of back ground noise,
and some reception interference.
Move the switch once to activate the function. Move the same switch to
cancel.
6) 4-PIN MICROPHONE PLUG:
This plug is situated on the front panel, thereby making it easier to set the
equipment into the dashboard. See the cabling diagram on page 39.
7) PTT (push to talk):
Depress this knob to transmit a message and release to listen to an incoming
communication.
A) DC-POWER TERMINAL (13,2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 W, Ø 3,5 mm)
C) TECHNICAL CHARACTERISTICS:
1) GENERAL:
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
2) TRANSMISSION:
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION:
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
28
: 40
: AM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V
: 115 (L) x 180 (H) x 35 (D)
: 0,8 kg
: Electret microphone with support,
mounting cradle, screws.
: +/- 300 Hz
: 4 watts AM PEP
: inferior to 4 nW (- 54 dBm)
: 300 Hz à 3 KHz in AM
: inferior to 20 µW
: 10 mV
: 1,7 A (with modulation)
: 1,8 %
: 0.5 µV - 113 dBm (AM)
: 300 Hz à 3 kHz in AM
: 60 dB
: 5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 500 mA nominal
800 mA maximum