Publicidad
Idiomas disponibles
Idiomas disponibles
b) Setting the lower limit value (displaying the sign of the lower limit value and
the lower limit value alternately by flashing) 0.00 - L L-.
Press the [TARE] key to enter the number input - increase the value with
•
the [ZERO] key and press the [*] key to confirm alarm setting.
If it is not necessary to change the lower limit value, press the [*] key while
•
the values are flashing alternately.
•
Press the [*] button to exit the settings directly.
If the lower limit value is not set to zero and is greater than the upper limit
•
value, error [-erro-] will be displayed.
c)
Setting the alarm mode.
The display shows - No- means no alarm;
The display shows - IN- indicates the alarm in the set range;
The display - OUT- indicates an alarm outside the set range.
•
Press the [TARE] key to toggle the three alarm modes and press the [*] key
to complete the setting.
If it is not necessary to change the alarm mode, press the [*] key to
•
complete the setting.
Caution:
IN- the sound signal rings in the set range;
OUT: the audible signal is ringing outside the set range.
In weighing mode, press [#] for 5 seconds and the scale will enter the user setting
mode (P mode). There are 18 modes from P1 to P18 - press [*] to select the mode
and press [TARE] to select the parameter.
1. P1 x kg Lb change
X = 1: kg display
X = 2: Lb setting (display does not indicate)
2. P2 x automatic power off
X = 1: lack of this function
X = 2: Power is turned off after 10 minutes
X = 3: 20 minutes
X = 4: 30 minutes
3. P3 x setting the band rate
X = 1: 9600
X = 2: 4800
X = 3: 2400
X = 4: 1200
Publicidad
