Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS FOR PREVENTION OF PROJECTILE HAZARDS
Wear impact-resistant safety goggles (EN 166).
Assess and determine the grade of protection required depending on the individual
case. The risks to others should also be assessed at this time.
On overhead work, wear a safety helmet (EN 397).
If a work piece, accessories, inserted tools, or the tool itself breaks, there is danger
from thigh velocity projectiles.
Before using the machine, check all parts for any damages. Replace damaged parts
immediately.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Only use machine tools, accessories and consumables, that are recommended by the
manufacturer. Make sure to choose the correct size and the correct type.
If the machine is fixed to suspension equipment make sure that it is secure.
Separate the machine form any external energy source before transportation.
Check that the machine is undamaged and in proper condition.
Basic Safety Instructions:
Caution
Skin exposure to hazardous dusts may cause severe dermatitis. Dust present at the
work place could be disturbed during the maintenance procedure and inhaled.
Clean machine and work place before maintenance work.
Only use original the manufacturer tools, in order to avoid causing damage.
Make sure that the technical data has been adhered to after all maintenance work.
Eating, drinking and smoking are forbidden during maintenance and repair work.
Maintenance and Repair Work on Pneumatic Equipment:
Warning
Air under pressure can cause severe injury.
Disconnect machine from air supply prior to maintenance and repair work.
Replace hose lines regularly as a preventative measure even when there is no
visible damage. (Pay attention to the manufacturer's information)
After completing maintenance and repair work and before restarting production
make sure that...
- all materials, tools and other equipment which were required for maintenance or
repairs have been removed from the work area of the machine.
- any fluid leaks have been removed.
- all safety devices on the machine are functioning properly.
After conclusion of maintenance or repair and prior to start of operation, make sure
to:
- check fixtures of screw connections.
- have reinstalled any removed container covers, screens or filters.
40
MAINTENANCE AND UPKEEP
Publicidad
