Urmet Elekta Steel 1060 Manual Del Usuario página 6

ENGLISH
WARNING! For a functioning of the device it is strictly necessary that the firmware version of the Ipercom
system is 2.1.0 or higher. The firmware version update of the Ipercom system is available on the Urmet
website in the Download/Software section.
1. DESCRIPTION
The device Ref. 1060/23 is an Elekta Steel vandal-proof call module for Ipercom system.
The main features are:
• Signal management using 3.5" graphic colour display and evolved graphic user interface (GUI).
• Simultaneous lock with pulse capacitance discharge (SE+; SE-) and no-voltage contact relay (C-NC-
NO) operation.
• Garage gate lock low current operation (SE2).
• Hall button input.
• Door sensor input.
• Audio repeat device control for use with hearing aid.
• LAN connection with RJ45 connector and Power Over Ethernet (POE).
• Set-up by means of 2 terminals for powering via local power supply Ref. 1039/20.
• Mifare Plus proximity key reader.
• Infrared proximity sensor for user detection.
• CMOS sensor colour camera with wide-angle lens.
• Alphanumeric keypad with 18 buttons, three of which multifunctional.
2. INSTALLATION
• Arrange the duct so that it ends in correspondence with the lower hole of the flush-mounting box.
• Remove the lower cap from the wire hole (1).
• Apply adhesive labels on the holes for the screws of the frame (2).
• Install flush-mounting box at indicated height (3).
• Fix the magnet (tamper) at the indicated height with the two-sided adhesive tape included (4).
• Fix the frame to the flush-mounting body (5).
• Make the electric connections.
• Fix the calling module to the frame (5).
A L T
O
T O
P
H A
U T
A
6
1
ALTO
TOP
HAUT
B
2
3
A L T
O
T O
P
H A
U T
DS1060-162A