ARDEA ONE CL200x-38 Manual De Instrucciones página 32

12
16. OPTIONAL ACCESSORIES
N.B. The tools and equipment needed for adjustments and/or assembly of original optionals
are not included. Always use quality tools to avoid damaging the structure and the materials.
16.1 Armrests (CLA210)
Remove the rear wheels and position the armrest at the desired height.
Use an appropriate tool to open the hole on the frame (if not already
open). Insert the through bolts provided with the kit and tighten them
completely. Repeat the operation on the other armrest.
16.2 Separate footplates (CLA211)
Lift the single footplate, loosen the through bolts on the frame, remove
the telescopic tubes of the single footplate and insert the support
tubes of the footplates, one by one. Insert the through bolts and
tighten completely. N.B.
sure they are properly attached with the clasps on the edges of the
footplates.
16.3 Extended single footplate (CLA212)
Lift the single footplate, loosen the through bolts on the frame, remove
the telescopic tubes of the single footplate and insert the support
tubes of the footplates, one by one. Insert the through bolts and
tighten completely.
16.4 Push handles (CLA240)
Remove the padded cover of the backrest and the elastic strap
protective cover. Remove the elastic straps. Remove the screws
securing the standard telescopic tubes, replace them with those
with push handles and adjust them to the desired height. Tighten
the screws, reinsert the elastic straps and then reposition the strap
protection cover and the soft padding on the backrest.
16.5 Support for inclining the backrest (CLA235)
Loosen the screws attaching the backrest to the frame, insert the
support for adjusting inclination and attach it to the frame with the
through bolts. Insert the backrest tubes into the support and secure
them with the through bolts after adjusting the backrest to the desired
inclination.
When lowering the separate footplates, make