Publicidad
Idiomas disponibles
Idiomas disponibles
5. Activate Folding Handle
Slide the lever to the side while
pulling up on the stroller handle.
6. Lock Stroller In Folded Position
Push frame together allowing
chassis lock lever to engage with
chassis lock knob.
NOTE: Stroller should be freestanding
on handlebar bumper and wheels
with handle adjusted to correct
position for balance.
CHECKING TIRE PRESSURE
Plastic wheels are rated to a
maximum tire inflation pressure of
30 pounds per square inch (psi).
The maximum inflation pressure is
embossed on the wheel next to the
valve stem and on the tire itself.
10
ADJUSTING THE TRACKING
If stroller pulls left or right when the
front wheel is in jog mode and stroller
is on flat terrain, adjust tracking as
outlined in the following steps.
WARNING!
Do not test with a child or any
occupant in the stroller.
1.
Empty Stroller
Remove child and all contents
from cargo basket and pockets.
2. Check Tire Pressure
3. Set Stroller to Jog Mode
Flip the locking switch towards
the front of the stroller. Rotate
fork/wheel until it snaps into rear
position. See Choosing Walk or Jog
Mode on page 5.
4. Place Stroller On Level Ground
Find a stretch of level ground
about 16 feet (4.9 m) long.
16 ft (4.9 m)
5. Align Rear Wheel Axles
Align stroller so rear wheel axles
are perpendicular to a straight
line.
90°
6. Test Alignment
Push stroller straight forward and
release to see if stroller veers right
or left. Repeat push test several
times.
NOTE: If stroller consistently pulls
to left or right, see Fine Tuning the
Tracking.
FINE TUNING THE TRACKING
If Stroller Pulls LEFT
If your stroller pulls LEFT, turn tracking
knob counterclockwise up to one half
turn.
Tracking Knob
If Stroller Pulls RIGHT
If your stroller pulls RIGHT, turn
tracking knob clockwise up to one half
turn.
Tracking Knob
REPEAT alignment test and adjust as
needed until stroller rolls straight.
SETTING THE PARKING
BRAKE
The parking brake prevents the stroller
from moving while loading and
unloading. The parking brake is not
designed as a stopping brake.
Locked Position
To set the parking brake, press down
on the foot pedal – making sure the
locking pin fully engages the locking
disk.
NOTE: Pressing the brake locks both
rear wheels.
NOTE: To ensure the brake is set
properly, attempt to roll the stroller
forward and backward after setting
the brake. If the stroller will not roll,
the brake is set properly.
Unlocked Position
To release the parking brake, lift up
on the foot pedal with your foot until a
click is heard and the pedal is fully in
the unlocked position.
11
Publicidad
