Windgoo B3 Manual Del Usuario página 7

Cleaning the electric bike
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or
solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or
ammonia-based cleaners as they may damage or dissolve the components.
When you are cleaning the bike, make sure the bike is switched off, is not connected
with the charging cable, and the charging port is covered with rubber cap, to avoid
serious damage caused to the bike by water getting inside.
Keep the bike in a dry and cool place and avoid long time outdoor storage when the
bike is not used. Long-time exposure to outdoor sun, excessive heat, and excessive
cold will speed up the aging of the bike outer in case and reduce the lifespan of the
battery.
Riding Guidance
Please check the brake before riding and brake the rear wheel first.Be careful of the
tightness of brake. Use the hexagon bar wrench to adjust if it's loose.
Keep a longer braking distance for safety reason in rainy and snowy days.
Please wear a helmet and comply with the traffic regulation and don't ride it in the
driveway. Don't ride it in crowded road.
When go downhill or on the slippery road, the speed should be under 15km/h.
Do not over loading beyond 120KG.
Maintenance
The front and back wheel should be at center of the frame. Put the electric bike at
cool and dry place after riding and check the motor and brake often,tighten the
screw if needed.
suggested torsion(unit,kgf.cm): Bar screws 60-80 kgf.cm, bar stand screws 175-200
kgf.cm, seat screws 175-250 kgf.cw, wheel screws 320-4SOkgf.cw
Check if the wheel has scratches and damages or excessive wear frequently, if the
inner wheel and the gas nozzle need be vertical to the hub,outer wheel should be
replace immediately with damage or scratches. Please contact the professional
technician to replace it. When the outer tire is pierced and leaks air, please contact
professional technician for repair or replace.
7