Maintenance / Troubleshooting - Triton TA 184CSL Instrucciones De Uso Y De Seguridad

• If either brush is worn to less than 6mm long, both
brushes must be replaced using genuine Triton
replacement brushes - available from Authorised Triton
Saw Repair Centres.
• Triton Precision Power Tools will not be responsible
for any damage or injury caused by mishandling or
unauthorised repair of this tool.
TROUBLESHOOTING
SYMPTOM
Saw will not operate
Poor performance
Vibration or abnormal noise
GB
Motor runs but blade won't
spin

Maintenance / Troubleshooting

12
PROBLEM
Power lead not plugged in
Power fault, fuse or circuit breaker
tripped
Brushes worn or sticking
Lead damaged
Faulty switch
Faulty motor
Extension lead too long
or undersized
Blunt or damaged blade
Motor is overloaded
Tool is overheating
Accessory not secured
Moving parts excessively worn
Mechanical obstruction
Armature has shorted sections
Blade retaining nut is loose
Broken gear shaft or teeth
POWER LEAD MAINTENANCE
If the power lead needs replacing, the task must be carried
out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard.
SUGGESTED REMEDY
Ensure that the power lead is connected to
the power supply
Check the power supply
Disconnect power, open brush caps and ensure
brushes move freely in the holders. Check
whether brushes require replacing as outlined in
the maintenance section.
Use authorised service centre**
to repair or replace the lead
Use authorised service centre**
to repair or replace the switch
Use authorised service centre**
to repair or replace the motor
Use extension lead heavy enough
to carry the current
Re-sharpen or replace blade
Reduce pushing force on saw. Ensure the cut
isn't closing and pinching the blade.
Turn off the tool and let it cool down to
room temperature. Inspect and clean the
ventilation slots.
Ensure that the saw blade is fully tightened
in the arbor washers
Use authorised service centre**
to repair or replace
Use authorised service centre**
to repair or replace
Use authorised service centre**
to repair or replace
Tighten blade retaining nut,
ensure the arbor washers are correctly fitted
Use authorised service centre**
to repair or replace