Worx Nitro WG325E Manual Original página 22

7. TROUBLESHOOTING TABLE
The following table gives checks and actions that you can perform if your machine does not operate
correctly. If these do not identify/remedy the problem, contact your service agent.
WARNING: Switch off and remove the battery pack before investigating fault.
Symptom
Pruning saw fails to
operate
Pruning saw
operates
intermittently
Chain/chain bar
over-heats
Pruning saw rips,
vibrates, does not
saw properly
22
Cordless Pruning Saw
Possible Cause
Out of battery.
Over heating
Applying too much pressure
while cutting.
Loose connection.
Internal wiring defective.
On/Off switch defective.
Chain is over tensioned
Dull chain
Chain tension too loose
Dull chain
Chain worn out
Chain teeth are facing in the
wrong direction
Remedy
Charge the battery pack.
Place the machine in a cool, ventilated
place to cool it down
Applying relatively less pressure while
cutting
Contact service agent.
Adjust chain tension
Sharpen chain or replace
Adjust chain tension
Sharpen chain or replace
Replace chain
Reassemble with chain in correct
direction
EN