MSW Motor Technics MSW-DCM-04 Manual De Instrucciones página 19

The MSW-DCM-04 model has a special lever lock. To use it, move the lever to
the lower position and lock it with the handle (located next to the tube
assembly) by turning it to the right. Thanks to this handle, the lever allows you
to conveniently carry the device. To release the lock, press the lever down and
turn the handle to the left.
Always be prepared to stop the machine immediately.
5) To remove the spiral, change the direction of its rotation. To do this, move the
lever to the upper position, set the switch to the "OFF" position, wait for the
engine to stop completely, then set the "REV" position and move the lever to
the lower position. Check the spiral at all times when pulling it out.
6) After unblocking is complete and the spiral is pulled out, set the lever to the
up position, turn the switch to the "OFF" position and disconnect the unit from
the power supply. Before rewinding the spiral, clean the device thoroughly.
3.3.1.
SPIRALS AND TIPS
To connect one end of the spiral to the other end/tip, insert the matching parts of
the spiral as shown in the picture. Then check that the connection is firm and that
the pin inside is visible. This is the only way to connect the spiral so it must be done
correctly. The manufacturer does not provide the possibility of connecting
tips/spirals of different diameters.
To disconnect, insert the included key into the hole located near the center of the
connection in such a way that the wedge on the key pushes the fixing pin inside.
Then, separate both ends by catching the spiral and/or the tip with both hands. The
key must be inside the hole when disconnecting.
3.4. Cleaning and maintenance
a) Before each cleaning, and also when the device is not in use, disconnect the
power plug and let the device cool down completely.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
HOW TO CONNECT/DISCONNECT