Publicidad
Idiomas disponibles
Idiomas disponibles
Pour approximately 220 ml oil into the oil refill port up to the
7.
upper limit of the oil gauge.
► 1. Oil gauge 2. Upper limit mark 3. 100 ml level 4. Lower limit
mark
After filling with oil, tighten the oil cap securely to prevent oil
8.
leaks.
Do not forget to put the oil cap gasket back on when
NOTICE:
reattaching the oil cap.
Cleaning of air cleaner
WARNING:
INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection
Daily (every 10 operating hours)
Cleaning procedure
3
2
1
► 1. Knob bolts 2. Air cleaner cover 3. Element 4. Breather
1.
Loosen the knob bolts.
Remove the air cleaner cover.
2.
Remove the element and clean off any dirt from the element with
3.
a cloth or air blow. Replace the element with a new one if it is dam-
aged or very dirty.
NOTE: The element is a dry type and should not get wet. Never
wash with water.
Wipe off any oil around the breather with a rag or cloth.
4.
Install the element in the air cleaner case.
5.
Attach the air cleaner cover and tighten the knob bolts.
6.
Clean the element several times a day, if excessive
NOTICE:
dust adheres to it due to dusty environment.
If operation continues with the element remaining
NOTICE:
not cleared of oil, oil in the air cleaner may fall outside, result-
ing in oil contamination.
Checking the spark plug
CAUTION:
running. Otherwise electrical shock may result.
CAUTION:
"O" position.
1
CAUTION:
plug cord is damaged or torn, replace it. Not doing so may cause
an electrical shock.
NOTICE:
and cylinder head first, so that no dirt, sand, etc., will enter the
cylinder.
NOTICE:
down in order to avoid damaging the threaded hole in the
cylinder.
2
NOTICE:
3
hole. If installed at an angle, the threaded hole in the cylinder will
4
be damaged.
1.
► 1. Plug cover
2.
4
remove and install the spark plug.
13 ENGLISH
Do not touch the spark plug while the engine is
Set the stop control lever/stop switch to OFF
Check the spark plug cord regularly. If the spark
When removing the spark plug, clean the spark plug
Remove the spark plug after the engine has cooled
Install the spark plug properly into the threaded
To open the plug cover, lift it and make a half turn of it.
Use the box wrench provided as an standard accessory to
1
Publicidad
