Location Requirements; Location Requirements (Cont.) - Whirlpool WFC8090GX Manual De Uso Y Cuidado E Instrucciones De Instalación

Location Requirements

Proper installation is your responsibility. Check code
requirements. Some codes limit, or do not permit, installing
washer/dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
You will need:
A separate 30 A circuit.
n
A grounded electrical outlet located within 2 ft. (610 mm)
n
of either side of washer/dryer. See "Electrical Requirements."
Water faucet located within 4 ft (1.2 m) of water fill valve
n
on washer/dryer, and water pressure of 20–100 psi
(137.9–689.6 kPa).
A level floor with maximum slope of 1" (25 mm) under entire
n
washer/dryer. Installing on carpet or surfaces with foam
backing is not recommended.
Floor must support washer/dryer's total weight (with water
n
and load) of 400 lbs (180 kgs).
For garage installation, place washer/dryer at least
n
18" (460 mm) above floor. If using a pedestal, you will need
18" (460 mm) to bottom of washer/dryer.
IMPORTANT: Do not install, store, or operate washer/dryer where
it will be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in washer/dryer after use may cause damage in
low temperatures. See "All-In-One Washer/Dryer Maintenance"
for winterizing information.
70
331⁄4" Min.
(845 mm)
333⁄4" Max.
(857 mm)
28"
(711 mm)
All dimensions show recommended spacing allowed, except for
closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of
installation and servicing, and spacing for companion appliances
and clearances for walls, doors, and floor moldings.
Space must be large enough to allow door to fully open.
Add spacing of 1" (25 mm) on all sides of washer/dryer to
reduce noise transfer. If a closet door or louvered door is
installed, top and bottom air openings in door are required.
24"
(610 mm)
48 / "
15
16
(1243 mm)