MSW Motor Technics MSW-TJ2500N Manual De Instrucciones página 24

height or the end of the lifting range has been reached. Place supports under the
vehicle.
LOWERING
Lift the vehicle slightly to remove the supports. Then use the lever to open the release
valve by turning the lever counterclockwise.
CAUTION: The further you open the release valve, the faster the vehicle is lowered,
but never open it completely - lowering the vehicle slowly allows you to better control
the process and react faster in case of unexpected situations! As soon as the vehicle
rests firmly on the ground and the saddle has lost contact with the chassis, drive the
jack out from under the car. Turn off the release valve by turning it clockwise.
CAUTION: If it is necessary to stop lowering the vehicle, close the release valve
immediately. The vehicle will stop at the given height.
TOPPING UP OIL
1. Lower the saddle.
2. Remove the plate and plug from the oil tank.
3. Top up oil.
4. Replace the plug and plate.
5. After each refill, vent the tanks as described above.
OIL CHANGE:
1. Open the release valve by turning it counterclockwise.
2. Remove the plate and plug from the oil tank.
3. Turn the jack to the side to drain the old oil.
4. Fill in new oil, replace the plug and plate.
7. After each oil change, vent the reservoir as described above.
CAUTION:
Do not pour alcohol, brake fluid or other unsuitable fluids into the oil tank. Chevron
Hydraulic Oil AW ISO 32 or Unocal Unax AW 150 is recommended.
3.4. Cleaning and maintenance
a) After each cleaning, all components should be well dried before the device s
used again.
b) Store the device in a dry and cool place protected from moisture and direct
sunlight.
c) Do not spray the device with a stream of water and do not immerse it in water.
d) Regularly inspect the device for technical failure and damage.