Before First Use; Operation; Cleaning And Care - Unold 87685 Manual De Instrucciones

BeFore FIrSt uSe

1. Remove all packaging materials and any
transport safety devices. Keep packaging
material out of reach of children. Danger of
suffocation!
2. After washing your hair, dry it thoroughly
with a towel.

oPeratIon

The plates of the hair straightener are coated to protect your hair and leave it shiny after straightening.
Nevertheless you should not straighten your hair too often. Select the adequate temperature for your
hair type, as too high temperatures may burn your hair. This applies especially to colour treated or
otherwise chemically treated hair (e.g. perms). In this case, select a lower temperature adjustment.
Before straightening your hair please do not use any chemical hair-styling products like hair spray to
avoid burning your hair.
The upper plate of your new hair straightener has a flexible support to allow straightening your hair
a more evenly.
attention: the appliance becomes very hot during operation. avoid direct skin contact. danger of burns!
1. Prepare your hair as described in the chapter
„Before first use".
2. Attention: your hair should be completely
dry before straightening. Straightening your
hair when it is still damp will damage your
hair. Therefore you should dry your hair well
using a hair dryer, if necessary.
3. Separate the combed hair into strands no
more than 5 cm wide. If necessary, separate
the strands using hair clips.
4. Connect the plug to a wall socket (220 -
240 V~, 50 Hz).
5. Switch the appliance on pushing the button
EIN/AUS [ON/OFF]. The control lamp lights
up.
6. Adjust the desired temperature using the
adjustment wheel. The thicker your hair, the
higher the selected temperature may be.
Chemically treated hair should be straighte-
ned at a lower temperature adjustment. You
may select between five temperatures from
150 to 230 °C.
7. Heat the appliance up for 2-3 minutes in
order to achieve the best styling result.
8. Open the appliance and place a small
section of hair between the straightening
plates close to the root.

cleanIng anD care

1. Unplug the appliance from the wall socket.
2. Let the appliance cool off completely placing it
on a heat resistant surface.
12
3. Best results are achieved with dry hair. Dry
your hair well using a hair dryer, if necessary.
4. Brush your hair until it falls loosely.
9. Shut the appliance.
10. Now work your way down slowly and evenly
to the ends of your hair. Maintain the appli-
ance firmly closed during this process.
Never work the same part for more than two
seconds to avoid damaging your hair. For
an even and straight look, work your way
straight down keeping the appliance close
to your head. Working your way through
slightly lifting the appliance will give your
hair more volume.
11. Please remember that the straightener
plates are very hot after use.
12. Always switch the appliance off using the
EIN/AUS [ON/OFF] switch before dis-
connecting the plug from the wall socket.
13. TIP: You can also curl your hair with the
straightener! Place the strand between the
plates as usual and straighten your hair.
Shortly before the ends of your hair, turn
the appliance to the inside or the outside
(according to the desired look) to give your
hair a gentle movement to inside or the out-
side.
attention: the appliance becomes very
hot during operation. avoid direct skin
contact. danger of burns!
3. Never immerse the appliance or the lead
cable in water or other liquids to clean them.
4. Clean the appliance with a damp cloth.