Home Decorators Collection 1009HDCGLDI Manual De Instrucciones página 12

Preparing the Remote Control
IMPORTANT POINTS TO REMEMBER
Please note that all fixed wiring appliances should be installed by a qualified electrician.

The supply to the remote control receiver should be connected through a mains switch, i.e.

existing wall switch.
Disconnect from power supply at wall switch before working on remote control

receiver or ceiling fan.
Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

This unit is to be used for the control of ceiling fan and in an AC110/120V 60Hz power

supply only.

Do not install in damp locations or immerse in water. (For indoor use only.)

Do not pull on or cut leads shorter. Do not drop or bump the unit.

CAUTION: To reduce the risk of fire or injury, do not use
this product in conjunction with any variable (rheostat) wall
control.
NOTE: The remote control has already been paired
to the ceiling fan for your convenience.
FUNCTIONS OF TRANSMITTER
Installing the battery
Install 12V A23 battery (included)
To prevent damage to transmitter,
remove the battery if not used for long periods.
Restore power to ceiling fan and test for proper operation.
○ ○○ ○○○
1. " , , ,"buttons:
These three buttons are used to set the fan
speed as follows:
○
= Low speed
○○
= Medium speed
○○○
= High speed
2. "  " button:
This button turns the fan off.
3. The " " button turns the light ON or OFF and also controls the brightness
setting. Press and release the button to turn the light ON or OFF. Press and
hold the button to set the desired brightness. The light key has an auto-resume,
it will stay at the same brightness as the last time it was turned off.
12
Please contact 1-800-986-3460 for further assistance.
Installation of Transmitter Wall
Mount Holder with one screw.
HOMEDEPOT.COM/HOMEDECORATORS