Omnifilter QK1 Manual Del Propietário página 2

INSTALLATION INSTRUCTIONS
ON 3/4" COPPER PIPE WITH THE
OMNI QUICK KIT:
The Omni Quick Connection Kit can be used
with the following Omni products: OB1, Pro-
900, R12, R14 and OB5 filters.
There are many ways to install your water
filter into a water line. This is a typical main
water line installation.
1. Open the package and locate all the parts as
shown in Figure 1.
Compression
Nut
Compression
Adapter
Nut
Valve
Adapter
Brass
Valve
Ferrule
Figure 1
2. Turn off the main water supply valve and
open a faucet to drain the system.
3. Unscrew and separate the head from the sump
portion of the filter housing. See Figure 2. Set
the sump aside.
Figure 2
4. Remove the brass compression nut and fer-
rule from each of the adapters and set them
aside.
All manuals and user guides at all-guides.com
5. Wrap 6"of Teflon tape on the "course"
thread of each adapter. Apply the tape in a
clockwise direction.
6. Thread the male adapters into the inlet and
outlet ports of the filter head. Start the
adapters by hand to avoid cross threading
them and then finish tightening the adapters
with a 1-1/4 wrench until they are snug. DO
NOT OVERTIGHTEN. See Figure 3.
Inlet
Port
Brass
Ferrule
Outside
Collar Edge
Figure 3
"Head" Portion
of Filter Housing
7. Measure the distance from the outside collar
edge of the inlet adapter to the outside collar
"Sump" Portion edge of the outlet adapter. Mark this dis-
of Filter Housing tance on the pipe.
8. Cut the pipe with a pipe cutter or hacksaw.
Sand or file the ends of the cut copper pipe
with sand paper or steel wool. Clean the ends
of the cut pipe.
NOTICE: Do not cut the pipe on an angle.
3708 0600 QK
Cutting pipe on an angle may cause it to leak
during use.
2
Outlet
Port
Wrap these
threads with
Teflon Tape TM
Adapter
Outside
Valve
Collar Edge