Makita DFL123F Manual De Instrucciones página 6

When using
When the tool is switched on, the lamps will light to indi-
cate the remaining battery capacity. When the tool is
switched off, the light goes out after approx. 5 seconds.
When pushing the check button with the tool switched
off, the indicator lamps turn on for approx. 5 seconds to
show battery capacity.
If the orange lamp flickers, the tool stops because of little
remaining battery capacity (Auto-stop mechanism).
Charge the battery cartridge or use a charged battery
cartridge at this time.
When the tool is used with the battery that has not been
used for a long time and is switched on, no lamps may
light up. The tool stops because of little remaining battery
capacity at this time. Charge the battery properly.
Switch action (Fig. 3)
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Reversing switch action (Fig. 4)
CAUTION:
• Always check the direction of rotation before operation.
LED indicator / Beeper
Led indicator / Beeper on the tool shows the following functions.
Function
This function works when the
tool has reached the preset
Auto-stop fastening torque and normal
fastening tightening has been completed.
This helps overtightening to be
avoided.
For approximately one second
after auto-stop fastening, the
Delayed re-start
tool does not start even if the
switch trigger is pulled.
Insufficient fastening has been
Warning against performed when the switch
insufficient trigger has released before
fastening reaching the preset fastening
torque.
This indicates the appropriate
Warning for
time to replace the battery
battery cartridge
cartridge when the battery
capacity
power becomes low.
This function works when the
Checking the
battery power is almost used
remaining battery
up. At this time, tool stops
capacity, Autostop
immediately.
This function works to check the
Check the LED proper operation of the LED
indicator, light and indicator, light and beeper when
beeper operation a battery cartridge has been
inserted into the tool.
6
Status of the LED indicator / beeper
Status
LED indicator
Lights up in green
for approximately
one second.
Lights up in red.
Flickers in red
slowly.
Lights up in red.
Lights up first in
green, next red
(And then the light
comes on.).
CAUTION:
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
• When not operating the tool, always set the reversing
switch lever to the neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for counter-
clockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
Lighting up the lamps (Fig. 5)
CAUTION:
• Do not look in the light or see the source of light
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be
careful not to scratch the lens of lamp, or it may lower
the illumination.
Beeper
—
A long beep
A series of long
beeps
A long beep
A series of very
short beeps
Action to be taken
—
Retighten the screw.
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
—