Publicidad
Idiomas disponibles
Idiomas disponibles
Do not expose the power tool to rain or operate it in wet or
damp conditions. The presence of water in a power tool
increases the risk of damage and electric shock to the user.
Hold the power tool by insulated surfaces only, which
prevent electric shock if the power tool comes into contact
with concealed wiring or the power cord during operation.
Never use the power cord to pull, carry or unplug the power
tool. Damaged power cords increase the risk of electric
shock.
Keep the power cord and plug away from heat sources, oil,
sharp objects and rotating attachments. Check the
condition of the power cord regularly, if it is damaged, it
must be replaced or repaired by a qualified technician.
Never change the power cord plug and use a socket which
is compatible with the plug. Do not use any kind of socket
adaptor.
The use of extension cords to plug in the power cord is not
recommended. However, if you use an extension cord, you
should take some precautions, such as:
▪ If you operate the power tool outdoors, use only
extension cords suitable for outdoor use. The use of a
suitable extension cord reduces the risk of electric
shock;
▪ Use only extension cords, plugs and sockets with earth
terminal;
▪ The cross-section of the extension cord's wires shall be
proportional to the length and with the same
characteristics
as
screwdriver's power cord;
▪ Do not use damaged extension cords. Examine the
extension cords before using them and replace if
necessary;
▪ Always unplug the extension cord before removing the
plug from the power tool;
▪ When using an extension cord reel, unroll the cord
completely.
or
larger
than
the
Ensure that the power tool is only used by persons familiar
with the operating instructions.
To ensure that you work safely with the power tool, you
should take certain precautions and procedures into
consideration before starting it up:
▪ Inspect the power tool before each use. Check that all
accessories are assembled correctly and in good
condition. If there is damage or excessive wear, replace
them;
▪ Check that all bolts are properly tightened. Regular
inspection is important to ensure safety issues and the
performance of the power tool;
▪ After the accessories' assembly and before using the
power tool, test it at full speed with no load for a while.
Check for moving parts misalignment or any other
condition that may affect the drywall screwdriver
operation. Check that all moving parts run smoothly,
without abnormal noises and sparks on the carbon
brushes;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or worn
out;
▪ Ensure that you don't press the ON/OFF switch when
plugging in the power cord. If the switch is damaged or
drywall
does not enable you to control the operation of the power
tool, it must be repaired or replaced in order to prevent
unintentional starting of the drywall screwdriver.
Make all adjustments and work necessary for the correct
assembly of the drywall screwdriver. If you have any
questions or difficulties, contact your official distributor.
Publicidad
