PNI Hunting 400C PRO Manual De Usuario página 7

EN
from the camera on the screen.
5. Press the OK button to make and send a test picture.
6. The status messages for the picture will appear on the screen: "Send SMTP"/"Send
Failed" and if applicable an error code.
7. If the message is "Send successfully" check your email address, including the
SPAM folder.
8. If the message is error, check again that the settings made are correct as indicated
above.
FAST CONFIGURATION WITH TRAILCAMERA APP
You can send basic settings to the camera, directly from the TrailCamera mobile
application, to quickly configure it, or to receive emails. Just enter a SIM card with
SMS, active Internet and no PIN (tested in a phone in advance) and turn on the
camera (the switch is on ON position) and check as indicated above for a signal in
the camera.
- Add in the app the phone number of the SIM inside the camera.
- Copy the settings in the image below and only modify your phone number and
email address with your own.
- Send the settings to the camera by pressing the Send button.
- The camera will respond with an SMS "SMS commands executed successfully!"
- Give the command "Get a picture" from the application and you will receive the
same SMS and an email with the photo taken by the camera.
- If it does not work, it means the product does not have the GSM signal, the Internet
or the correct settings made. Check the settings again and remove the camera in
the open field where you have at least 2 signal lines. Please also carefully check the
camera settings.
User manual 7