Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INTRODUCTION
Thank you for the purchase of our quality product. Used carefully and in accordance with the instructions
set out below. Please read and keep these instructions for future reference.
INSTALLATION
After removing the packing materials, check the in-
tegrity of the fan; If you are not sure, do not use it
and seek qualified professional help. Packaging ma-
terials (plastic bags, Styrofoam, nails, etc.) must be
kept out of the reach of children as they are potential
sources of danger.
Before connecting the appliance, check that the
voltage values shown on the data plate correspond
to those of the power supply network. In case of
incompatibility between the electrical outlet and the
fan plug, have the outlet replaced by a more suita-
ble type by professionally qualified personnel, who
will ensure that the section of the outlet cables is
adequate for the power absorbed from the fan. In
general, the use of adapters or extension cords is
not recommended; If their use is essential, they must
comply with existing safety regulations and their cu-
rrent capacity (amperes) must not be less than the
maximum of the appliance.
The outlet should be easily accessible so that the
plug can be quickly removed in an emergency.
Do not place the appliance near sinks or any other
container for liquids (minimum distance of 2 meters)
to avoid the risk of it falling.
Keep the fan away from unstable fabrics (curtains,
etc.) or materials that could obstruct the air intake
grille; make sure the front is free of unstable materials
(dust, etc.).
Make sure that the power cord does not touch rou-
gh, hot or moving surfaces and that it is not twisted
or wrapped around the appliance.
Support the appliance on a horizontal and flat sur-
face or table; do not stand on an inclined plane (the
appliance could be disturbed).
In case of breakdown or malfunction, turn off the fan
and seek professionally qualified help.
ASSEMBLY
Attention: the fan can only be used if it is completed
with the support base (base1 and base 2).
20 | www.garsaco.com
Attention: unplug the appliance before mounting it.
To assemble it, refer to the figure: first placing base 1
(D) then base 2 (E) on the body, making sure to lock
with 4 supplied screws (F);
A
B
A. Power switch button
B. Speed switch button
C. Rocker button
D. Timer button
REMINDER: There are 2 corresponding holes on the
base, the 2 pillars on the seat must pass through the-
se 2 holes when the base is assembled on the fans.
Attention: unplug the appliance before mounting it.
Avant chaque utilisation, vérifiez que l'appareil est
en bon état et que le cordon d'alimentation n'est
pas endommagé ; Si le cordon d'alimentation est
endommagé, il doit être remplacé par le fabricant
ou un électricien qualifié compétent ou une person-
ne de qualification similaire pour éviter tout risque.
D
C
Publicidad
