Renfert Waxlectric light I Manual De Instrucciones página 21

5.2 Temperature Adjustment
The modelling tip temperature is adjusted with the aid of knobs C and D (Fig. 12).
After a temperature adjustment, the modelling tip requires several seconds to reach the new temperature
setting�
NEVER attempt to heat the tips more rapidly by holding them in an open flame. This will destroy
the tips.
Please retighten the inserted modelling tip after heating up!
The employed heating elements have been specially tailored to the individual modelling tips�
However, manufacturing tolerances may result in minor differences between the set temperature
and the actual temperature at the modelling tip.
5.3 Storing the Modelling Tips and Handpieces
You can safely leave unused modelling tips in the tip holder for storage (Fig. 13).
During breaks, you can safely leave unused handpieces in the quiver (Fig.14).
NEVER insert the handpieces into the tip holder (Fig. 15). This can damage both the tip holder as
well as the control unit.
NEVER place the handpiece on a flammable surface or cover it! Fire hazard!
Tip holders and quiver are available as separate accessories (refer to "Accessories").
Tips and Notes
• In order to reduce the risk of breaking the probes, dip them into the hard wax block with the
rounded back section! The wax will melt more quickly and this allows to pick up a greater amount
of wax (Fig. 24).
• More rapid and efficient modellation (time savings of up to 30 %!) can be achieved by pre-warm-
ing the wax in a Renfert Vario E� Wax can be processed more gently and cools more rapidly�
This reduces shrinkage to a minimum�
• Because the tip insert surfaces are not finished, they can – starting from their basic shape – be
ground, bent, or polished to suit your particular requirements�
• The handpiece cables can be guided through an appropriate retainer (eye, hook, etc.) to allow
the handpieces to hang down from above the work area at the ideal height� This "cable / hand-
piece overhead suspension" permits significantly faster handpiece access / changeovers.
• By setting the temperature at approx. 50 °C [122 °F], you can use the slightly warmed Waxlectric
blade to "shave" the wax crown edge onto the die while the wax is warm�
6 Cleaning / Maintenance
Never rinse the unit off with water!
Do not use steam to clean the unit! Hot steam penetrating the unit can damage it.
⇒ Use a soft, lint-free cloth to wipe the unit down from time-to-time�
Never use cleansers containing solvents!
⇒ Wipe the tips off after use; This will prevent wax from burning onto the tip and maintain the tip's optimal
heat conducting properties�
6.1 Changing Tips
Burn hazard!
The modelling tips may be hot. Always allow the tips to cool before changing them.
• Unscrew the tip (Fig. 16).
• Make sure the O-ring is properly seated (Fig. 17).
• When the tip is brand new, ensure that the contacts are clean�
• Insert the new tip, making sure it is straight, and hand-tighten it� Make sure the tip IS NOT skewed or
cross-threaded (Fig.18).
Make sure the O-ring is properly seated (Fig. 17), the O-ring provides a seal against the wax.
Modelling tips which are not being used can be safely and handily stored in the tip holder (Fig. 13).
- 7 -
EN