Pioneer PRS-X340 Manual Del Propietário página 5

LPF (Low-Pass Filter)/HPF (High-Pass Filter)/BPF (Band-Pass Filter) and
LOW/HIGH Select Switch
Set the LPF/HPF/BPF and LOW/HIGH select switch as follows according to the type of
speaker that is connected to the speaker output connector and the car stereo system:
LPF/HPF/BPF
and LOW/HIGH
Select Switch
LPF HIGH
LOW
HPF HIGH
LOW
BPF (for CH A)* 4
OFF
* 1 See the "Cut Off Frequency Control" section.
* 2 With CH A, even if the setting is HPF-HIGH, you can only select the same cut off frequency as with
HPF-LOW (40 to 120 Hz).
* 3 If you connect the tweeter directly, you must set the CH B to HPF-HIGH.
* 4 Be sure to set the LOW/HIGH select switch to HIGH.
All manuals and user guides at all-guides.com
Audio frequency range
to be output
* 1 — 3k to 9k Hz
* 1 — 40 to 120 Hz
* 1 * 2 3k to 9k Hz —
* 1 40 to 120 Hz —
* 1 40 to 120 Hz —
— 3k to 9k Hz
Full range
RCA Input Select Switch
For two-channel input, slide this switch
to the left. For four-channel input, slide
this switch to the right.
Speaker Remarks
Type
Mid Connect a mid range speaker.
Subwoofer Connect a subwoofer.
Tweeter* 3 Connect a tweeter.
Full range Use if you want to cut the
very low frequency range*
because it is not necessary for
the speakers you are using.
Mid Connect a mid range speaker.
Full range
1
4