Publicidad
Idiomas disponibles
Idiomas disponibles
Key Pad Features (Models RAC-WK08 / 10 / 12)
Connect Indicator Light
(Smart models only)
Timer
Sleep
Button
Button
TO TURN UNIT ON OR OFF:
Press Power button to turn unit on or off .
NOTE: The unit will automatically initiate the Energy
Saver function under Cool, Dry, Auto modes.
TO CHANGE TEMPERATURE SETTING:
Press UP/DOWN button to change temperature
setting.
NOTE: Press or hold either UP (
button until the desired temperature is seen on
the display.
This temperature will be automatically
maintained anywhere between 62°F (17°C) and
86°F (30°C). If you want to display the actual room
temperature, see To Operate on Fan Only section.
TO ADJUST FAN SPEEDS:
Press the Fan Button to change the fan speed
between four settings – Auto, Low, Med, or High.
The fan will operate on Low Speed automatically
when set to Dry Mode.
On Auto mode,the fan operates on Auto fan
speed automatically and cannot be changed.
SLEEP FEATURE:
Press Sleep button to initiate the sleep mode.
In this mode the selected temperature will
increase by 2°F (1°C) 30 minutes after the mode
is selected.
The temperature will then increase by another
2°F (1°C) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before
it returns to the originally selected temperature.
User Manual
LED
Display
Up ( ) and Down ( )
Mode
Button
Buttons
) or DOWN (
)
Fan
Button
The Sleep mode program can be cancelled at
any time during operation by pressing the Sleep
button again.
CHECK FILTER FEATURE:
The Check Filter feature is a reminder to clean
the air filter for a more efficient operation.
The light will illuminate after 250 hours of
operation. After cleaning the filter, press the
Filter button to reset the Check Filter function
turning the light off.
ENERGY SAVER FEATURE (ECO):
Press Energy Saver button to initiate this
function. This function is available on COOL,
DRY, AUTO (only AUTO-COOLING and AUTO-
FAN) modes. The fan will continue to run for
3 minutes after the compressor shuts off.
The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature is
above the set temperature, at which time the
compressor turns back on and Cooling resumes.
TO SELECT THE OPERATING MODE:
To choose the operating mode, press the Mode
button. Each time you press the button, a mode is
selected in a sequence that goes from Auto, Cool,
Dry and Fan. The indicator light adjacent will be
illuminated and remain on once the mode is selected.
When the unit is turned off and back on via the
power button, the unit will automatically switch on
the Energy Saver function for the following modes:
Cool, Dry, Auto.
Power
Button
Energy
Clean
Saver
Filter
Page 13
Publicidad
