Publicidad
OPERATING INSTRUCTIONS
h. Replace the outer washer (Q). Align the outer washer with the spindle shaft until it
engages (Fig. 2b).
i.
Replace the wheel bolt (R) (Fig. 2b).
j.
Hold the outer washer (Q) still using the flat wrench (D) (Fig. 2a).
k.
Tighten the wheel bolt securely by turning it COUNTERCLOCKWISE with the "T" wrench
(P) (Fig. 2a).
2b
Inner Washer
NOTICE:
• Do not overtighten the wheel bolt (R).
• Never use a cut-off wheel that is too thick to
allow the outer washer to engage with the flat on
the spindle.
• After the saw blade is installed, place the "T"
wrench (P) and the flat wrench (D) in their
dedicated storage locations.
• To prevent the flat wrench (D) from falling off
during operation, the raised feature on the flat
wrench should be facing up (Fig. 2c).
• There is a fastening rubber block in the "T"
wrench storage slot. When storing the wrench
(P), press it firmly into place.
3. Preparing the Water Tank
Prior to using the tool with the water tank, inspect
the tank for holes cracks or other damage. Replace
with identical replacement water tank if a potential
weakened or damaged area is detected.
WARNING
• Risk of electric shock. Remove the water tank
before filling it. Do not let the water to get on
the battery pack or battery pack port.
a. Remove the battery pack.
b. Release the tank: press the water tank install/
release button (L) to remove the tank (J) (Fig. 3).
Spindle
Shaft
Water Supply
I
Rotation Arrow
H
Q
D
2c
D
Raised
Feature
3
13
R
P
P
K
J
Black rubber
cover
L
Publicidad
