Publicidad
Idiomas disponibles
Idiomas disponibles
7. INSTALL THE ADAPTER
Remove the 10-inch round adapter from inside the power pack, and
install it on the top using 2 no. 8-18 x 3/8" Phillips screws, and the small
notches around the adapter.
8. CONNECT WIRING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power from being switched on accidentally.
From inside the power pack, remove the wiring box cover by removing both
retaining screws and set aside. Install the wire clamp included in the parts bag in
the electrical hole in the back of the hood.
Position the power pack below the installed custom hood.
Insert the house wiring cable through the wire clamp, and tighten the wire clamp
to secure the cable. Connect the cable into wiring box using waterproof wire
connectors. Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire
under GREEN ground screw. DO NOT FORGET TO CONNECT THE GROUND.
Reinstall wiring box cover, making sure not to pinch wires.
W
ATERPROOF WIRE CONNECTORS INSTRUCTIONS
1. Strip wires 3/8".
2. Align frayed strands or conductors.
3. Do not pre-twist. Place stripped wires together with ends even, but lead smaller stranded wires slightly ahead of larger solid or
stranded wire.
4. Twist connector onto wires pushing firmly until hand-tight. DO NOT over torque.
5. When inserting wires into connectors, some sealant may leak out. Wipe off excess sealant in and around conductors. DO NOT REUSE.
WARNING
!
:
6
HJ0185
HE0059
Publicidad
