Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING PROCEDURE
NOTE: Before using the tool, read the instruc-
tion book carefully.
1. RECHARGING BATTERIES
A] CHARGING THE BATTERY
To the Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off by
means of a protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack
may become too hot. Allow time for the battery to cool
down before recharging.
B] IMPORTANT NOTES FOR CHARGING THE BATTERY
The battery in your new tool is not charged when it leaves
the plant. Therefore it must be charged for 1 hour before
using the first time!
C] CHARGING (SEE A)
Plug the charger plug into a suitable mains socket, and the
indicator light will show green. Then insert the battery pack
into the charger, the indicator light will become red to red
to indicate that charging is taking place.
a.Connect the power cord of the charger with a wall socket
.The charger LED turn green
b.Slide the battery as far as it will go into the charger, by
inserting the battery terminal into the suitable opening of
the charger.
c.The charging LED turn red, and the battery three LEDS
start flashing continuously from one to another.
d.When with about 30% capacity, the battery three LEDS
start flashing continuously from one to another.
e.When with about 50% capacity, one battery LED keep
shining and two other LEDs start flashing continuously
from one to the other.
f.When with about 75% capacity, two battery LEDs keep
shining and the other LED start flashing continuously .
g.when finish charging, three battery LEDs keep shining for
about 10 minutes and then turn off.
After charging 30 min (2.0 Ah), the battery will be fully
charged. When fully charged, the light(a) will turn to green.
Unplug the charger plug form the wall socket, the tool is
ready to use.
/ A /
¡WARNING!
When battery charge runs out after continuous-
ly use or exposure to direct sunlight or heat,
allow time for the battery to cool down before
re-charging to achieve the full charge.
2. TO REMOVE OR INSTALL THE BATTERY PACK
(SEE B)
Locate button on front of the battery pack. Depress the bu-
tton to release and slide it out from the tool. After recharge,
insert back into the tool. A simple push and slight pressure
will be sufficient.
/ B /
OPERATING INSTRUCTIONS
The batteries are supplied partially charged and therefore
must be fully charged before being used for the first time.
- Charge the battery when the appliance runs slowly or
stops.
- A lithium ion battery can be charged at any time without
shortening its life. Interrupting the charging process will
not damage the accumulator.
- A lithium ion battery is protected by the electronic cell
protection against deep discharge.
- A significantly shorter run time of a charged battery
means that the battery life is over and the battery needs
to be replaced.
Original replacement batteries for exclusive use.
CHAIN ASSEMBLY
01
03
05
3
02
04
06
EN
Publicidad
