Taking photos
Slide the function selection switch to
the desired position .
Hold down the P O W E R button for
2 seconds. The camera will vibrate
briefly 3 times to signal that the de-
vice is now switched on.
The operating LED will light up blue when the de-
vice is switched on.
Press the R E C O R D button. The camera will vibrate
briefly 2 times and then automatically takes the pho-
to of the desired subject.
Press the R E C O R D button again to take another
photo
NOTE!
The recording LED only lights up if a memory
card has been inserted into the device.
If there is no memory card inserted in the de-
vice or the card has been incorrectly inserted,
the charging LED on the rear of the device will
blink.
EN
17