Publicidad
Idiomas disponibles
Idiomas disponibles
COVER MATERIAL CARE INSTRUCTIONS
The material covering this piece of furniture is very durable for everyday living. It is recommended by the manufacturer
to only clean this material with water-based cleaning agents or soap. Lightly scrubbing will help with any tougher spots
that may have developed. Always check a small spot of material in an area that is unseen to be sure the cleaning agent
being used will not discolor or fade the material's finishing. Let the chair air dry and vacuum for the best result.
CHAIR ASSEMBLY - CORD AND POWER TRANSFORMER CONNECTIONS
WARNING: It is important that you read and carefully follow all chair assembly instruc�ons. Do not plug the power
cord into an electrical outlet un�l all assembly has been properly completed. Failure to follow all chair assembly instruc�ons
may cause the chair to operate improperly possibly resul�ng in the risk of personal injury or death.
CHAIR ASSEMBLY
Once the chair is removed from the box, you'll no�ce the back is lying on the top of the seat. There are couple of items
to remove from the seat por�on of the chair first. Follow below instruc�ons:
1. Some models have back wings which are a�ached, when unpacking your chair you will find these back wings packed in
the back of the chair base,
2. Locate the hardware pack that contains the power transformer, power cord and the control wand. This can be done by
turning the base over on its arms, you will see the plas�c bag �ed to the inside of the unit, Carefully cut the �es that
hold the bag and remove it. Dispose of the �es and bag properly.
3. If your chair uses a control wand. Remove the control wand from the plas�c bag and connect it to the female plug
located in the le� side pocket of the chair,
FIGURE A
2
This Class B digital device complies with part 15 of FCC rules. "Opera�on is subject to following two condi�ons: (1) this
device may not cause harmful interference, and (2) this device must accept any interference, including interference that
may cause undesired opera�on. To comply with the FCC RF exposure requirements, no change to the antenna or device
is permi�ed Any change to the antenna or device could result in the device exceeding the RF exposure requirement and
void users right to operate device
SIGNATURE DESIGN BY ASHLEY
Please unpack the back wings and set them aside for installa�on later.
Figure A #1
Figure A #3
1
Plug
4
Transformer
in Here
C
5
6
B
A
Power Transformer and Cord
All Rights Reserved.
Figure A #2
Wand in
3
Side Pocket
Aug. 2022
00172D
Page 3 Of 26
Publicidad
