Publicidad
Idiomas disponibles
Idiomas disponibles
4. Lower the needle threader lever 6 on the left
side of the machine as much as possible.
The thread passes through the eye of the
needle.
5. Release the needle threader lever 6 .
6. Carefully pull the loop of the thread through
the eye of the needle to pull out the end of the
thread.
7. Raise the presser foot lifting lever 1 , then
pass the end of the thread through the presser
foot, and then pull out about 5 cm (2 inches) of
thread toward the rear of the machine.
5 cm
Threading the right needle
1. Slide the needle threader chenge switch <A>
to the "R" mark on the machine.
2. Run the thread in the sequence illustrated,
following the green color and the number next
to each threading point.
a) Pull the thread off the spool and directly up
through the thread holder 1 and the thread
holder 2 on the thread tree from back to front.
b) Hold the thread with your left and right hands,
then pass the thread through the thread guide
3 , and then pass the thread through the
tension disc 4 which is in the channel next to
the green thread tension dial.
c) Guide the thread down the channel and
across through the threading points 5 6
7 next to the green color marks following
the numerical order in the accompanying
illustration.
Two needles
NOTE:
Make sure the thread is through the right of the
separater <B>.
You can use the needle threader in the same way
as for the left needle. (See "Using the needle
threader")
NOTE:
For details on these operations, watch the video.
https://s.brother/cvtkb/
One needle
19
Publicidad
