Watch your hands.
Do not fold before power off.
15
Take care of your belongings.
Do not get on and off when the
treadmill operating.
7. Maintenance and Adjustments
1. Clean the treadmill
• Disconnect all sources of power before cleaning the treadmill.
• Add a small quantity of mild cleaner to a 100% cotton cloth. Do not spray the cleaner directly
on the walking belt or use acidic and corrosive cleaner.
• Do not wipe under the walking belt.
• After a period of exercise, dust and stains may appear on the rear floor. This is normal and
can be simply wiped.
• Simultaneously press and hold both Mode Button and Speed Increase Button on the remote
control for over 3 seconds until device start.
• Front panel will show "CALI" and keep running with speed 3km/h (2mi/h).
2. Walking Belt Slipping and Correction
• Walking belt goes to the left: Turn the left adjusting hole screw clockwise by 1/4 turn.
• Walking belt goes to the right: Turn the right adjusting hole screw clockwise by 1/4 turn.
• Walking belt is slipping: Turn the left and right adjusting screws clockwise for 1/2 turn at the
same time.
• After each adjustment, the treadmill needs to run for 1-2 minutes to verify the adjustments.
Please adjust again if necessary.
• Press the function key to stop treadmill.
CAUTION: DO NOT OVERTIGHTEN THE BELT. PLEASE MAINTAIN ORIGINAL FACTORY
BELT TENSION. EXCESSIVE BELT TENSION WILL CAUSE DAMAGE TO MOTOR.
• Power off the treadmill and unplug the power cord.
• Lift the edge of the walking belt and smear the inner surface with silicone oil.
• Start the treadmill to run at a speed of 3 km/h (2 mi/h) for 10-20 seconds.
• 5-10 ml of silicone oil is required for each lubrication. Excessive silicone oil may cause
slipping and affect normal use.
• Lubricate the walking belt every three months.
3. Walking belt lubrication
16