Hendi 860083 Manual Del Usuario página 7

Main parts of the product
(Fig.1 on page 3)
1. Lid with hinge
2. Support ring
3. Inner pot stainless steel
4. Aluminium pot
5. Knob
6. Energy regulator
7. Signal light
8. Element 230V 400W
9. Hi-limiter
Circuit diagram
(Fig.2 on page 4)
1. Heat Indicator Lamp
2. Heat Protector
3. Temperature Protector
4. Heating Element
5. Thermostat
6. Single Circuit Energy Regulator
7. Ground
Preparation before use
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged and with
all accessories. In case of incomplete delivery and damages.
Please contact supplier immediately. Do not use the appliance.
• Clean the appliance before use (See == > Cleaning & Mainte-
nance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in the
future.
Operating instructions
• Fill the tank with sufficient water. Empty trays should just
float.
• Use the thermostat knob to set the desired power level.
Caution!: Always ensure that there is sufficient water in the
tank! Check this regularly, also during use.
Cleaning & maintenance
ATTENTION! Always disconnect the appliance from the elec-
trical mains and cool down before storage, cleaning & main-
tenance.
Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
Cleaning
• If used intensively, regularly remove lime scale from the bot-
tom of the water tank
• Never immerse the appliance in water or any other cleaning
fluid
• Clean the appliance with a damp cloth
• Never use aggressive or corrosive cleaning agents
• Avoid as much as possible water contacting the electrical
components
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems Possible cause
Appliance does not No power at the
work power point
The plug is not
plugged (correctly)
into the power
point
Appliance does not Heating element
reach the set tem- faulty
perature
Control unit faulty
Heating element
fuse faulty
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
ranty, state where and when it was purchased and include proof
of purchase (e.g. receipt).
In line with our policy of continuous product development we
reserve the right to change the product, packaging and docu-
mentation specifications without notice.
Discarding & Environment
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose
to your waste equipment by handing it over to a
designated collection point. Failure to follow this
rule may be penalized in accordance with applicable regula-
tions on waste disposal. The separate collection and recycling
of your waste equipment at the time of disposal will help con-
serve natural resources and ensure that it is recycled in a man-
ner that protects human health and the environment.
For more information about where you can drop off your waste
for recycling, please contact your local waste collection compa-
ny. The manufacturers and importers do not take responsibility
for recycling, treatment and ecological disposal, either directly
or through a public system.
GB
Possible solution
Check the fuse
Check the plug
Contact the
supplier
Contact the
supplier
Contact the
supplier
7