Kärcher BR 30/15 C Manual Del Usuario página 13

– Brush high-fiber rugs in the direction of
the weave after cleaning (using a fiber
brush or a scrubber).
– Do not step on cleaned surfaces until
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
– When cleaning previously shampooed
carpets, foam will be generated in the
dirt water reservoir. In such a case add
Foam ex RM 761 to the dirt water reser-
voir.
Shutting down
 Set the appliance switch to "OFF".
 Empty the dirt water reservoir.
 Pull the drain hose for the fresh water
off the hose nipple an drain the deter-
gent solution.
Cleaning the device
 Fill the fresh water tank with approx. 2
liters of hot water (max. 60°C) and flush
the spray system by pressing the deter-
gent solution key.
 Disconnect the mains plug from the
socket.
 Pull the drain hose for the fresh water
off the hose nipple an drain the deter-
gent solution.
 Clean the sieves on the fresh water
tank and inside the dome.
 Rinse the waste water tank with clear
water.
 Tilt the appliance backwards and clean
the cleaning head and the vacuum bar..
Frost protection
In case of danger of frost:
 Empty the fresh and dirt water reser-
voirs.
 Store the appliance in a frost-protected
room.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Use the pushing handle to push the ap-
pliance.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
DANGER
Danger of injury by electric shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Maintenance intervals
Daily before use
 Check high power cable, extension ca-
bles and hoses for damage every time
before use.
 Check spray pattern of the nozzle.
CAUTION
Risk of damage. Never use a wire or a nee-
dle to clear plugged nozzles, but rinse them
with hot water (see "Troubleshooting").
Every 25 operating hours
 Check hoses and seals to see if there
are damages. Have defective parts re-
placed by Customer Service.
 Check the brushes for wear, replace if
required.
The brushes are considered worn, if the
bristles have the same length as the
yellow indicator bristles.
– 4
EN
Transport
Storage
13